Stanley
August 18th, 2007, 01:31 AM
At this stage you should pair your Bluetooth GPS Receiver before launching TomTom.
Start>Settings>Connections>Bluetooth> Turn on bluetooth.
Turn on your Bluetooth GPS receiver.
Click on “devices” tab and then on “new Partnership”
Wait for the scan.
Select “BT GPS” (or whatever your's is called).
Click on "next" Enter passkey (mine was "0000")
Check your GPS Receiver's manual.
Click on "next"
Once properly paired, put a check next to "Serial Port" as the device's available service.
click "Finish".
Click on "COM Ports" Tab
Click "New Outgoing Port", select "BT GPS" (or whatever your's is called).
click "next".
Set COM port to "COM4", while leaving Secured Connection still checked.
If that doesn’t work, choose a different COM port.
Click "Finish" and your device should now be listed with (COM4) next to it.
Now load up TomTom.
During setup you will be asked to specify your GPS hardware.
Select "Other Bluetooth GPS" then select "COM4".
PLEASE NOTE:
In future you don’t need to enable bluetooth, just load Tom Tom and it does it for you.
PLEASE NOTE:
IF FLIGHT MODE ON YOUR PDA IS ON, YOU WILL NOT GET A GPS SIGNAL, EVEN IF BLUETOOTH IS ON
Start>Settings>Connections>Bluetooth> Turn on bluetooth.
Turn on your Bluetooth GPS receiver.
Click on “devices” tab and then on “new Partnership”
Wait for the scan.
Select “BT GPS” (or whatever your's is called).
Click on "next" Enter passkey (mine was "0000")
Check your GPS Receiver's manual.
Click on "next"
Once properly paired, put a check next to "Serial Port" as the device's available service.
click "Finish".
Click on "COM Ports" Tab
Click "New Outgoing Port", select "BT GPS" (or whatever your's is called).
click "next".
Set COM port to "COM4", while leaving Secured Connection still checked.
If that doesn’t work, choose a different COM port.
Click "Finish" and your device should now be listed with (COM4) next to it.
Now load up TomTom.
During setup you will be asked to specify your GPS hardware.
Select "Other Bluetooth GPS" then select "COM4".
PLEASE NOTE:
In future you don’t need to enable bluetooth, just load Tom Tom and it does it for you.
PLEASE NOTE:
IF FLIGHT MODE ON YOUR PDA IS ON, YOU WILL NOT GET A GPS SIGNAL, EVEN IF BLUETOOTH IS ON